SK15 infrared lamp for glass

Sun, 07 Jun 2026 02:30:24 +0800

On the glass line, heat isn’t just a temperature number. It’s timing, it’s distribution, and it’s repeatability. When the heat profile starts to drift, you feel it immediately—optical distortion in bending, uneven temper in safety glass, weak edges in lamination, and pinholes in coatings. The SK15 infrared lamp was built to take the guesswork out of these thermal steps. What matters, technically The SK15 runs on short-wave infrared, so you get fast, directional heating with minimal convection. That translates into quick response and tight control over the glass surface temperature curve. In practical terms, you can match the heating rate that complex bending molds demand, hit the preheat window right before quench in tempering, and hold the cure profile EVA/SGP/PVB lamination needs—without overshooting. It’s engineered for industrial work: stable output over long cycles, consistent hot-zone uniformity, and straightforward integration into existing conveyor and oven zones. Why it holds up on the floor In hot bending, the SK15 tightens the soak window while keeping the thermal gradient under control—fewer edge waves and less springback. For tempering, it delivers the fast, even preheat that helps produce consistent break patterns and reduces edge stress. In lamination, it brings the interlayer to flow temperature quickly and evenly, so you cut dwell time and improve edge bond strength. For coating drying, the focused heat minimizes solvent blistering and improves film adhesion. Across all four uses, you get shorter cycle times, lower energy draw per piece, and fewer rejects tied to thermal nonconformities. A few shop-floor realities Mounting and alignment matter. The SK15 performs best when the focal distance and reflector geometry are matched to the target glass thickness and line speed. There’s a brief warm-up stabilization period after each start-up, and keep the lamp surface clean—especially in dusty or high-humidity areas—so output stays repeatable. If your line runs frequent thickness changes, plan those adjustments upfront. The payoff isn’t just a hot lamp; it’s a stable process window.

SK15 on Warm IR Heater Core Tech

SK15 infrared lamp for glass